Maintenance - Stanley SL18129 Manual Del Propietário

1. Crevice tool (part E) -It is suitable for sucking and cleaning the corners and niches where can't be reached by other
accessories. Besides, it can be used as blowing tool. （Picture 16 & 17）
2. Bristled floor brush (part D) - It is suitable for cleaning wide areas. Use on bare floors and carpets. （Picture 18）
3. Wide angle tool (part C) - It is suitable for cleaning the dust on the carpet, sofa and mattresses.（Picture 19）

MAINTENANCE

FILTER
WARNING!
TO REDUCE THE RISK OF INJURY FROM ACCIDENTAL STARTING, UNPLUG POWER CORD BEFORE
CHANGING OR CLEANING FILTER.
NOTE: The cartridge filter (part J) is made of high quality paper designed to stop very small particles of dust.
The filter can be used for dry pick up or small amounts of liquid. Handle the filter carefully when removing to clean or
installing it. Creases in the filter pleats may occur from installation but will not affect the performance of the filter.
NOTE: The disposable filter (part K) can only be used for dry pick up. Please do not use for wet pick up.
FILTER CLEANING
IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears in it. Even a
small hole can cause a lot of dust to come out of your vacuum. Replace it immediately.
FILTER REMOVAL
To remove the filter for cleaning or replacement, unscrew the filter
cover from the filter cage and lift off filter.
IMPORTANT: To avoid damage to the motor and injury, always reinstall the filter (part J or K) before using the vacuum
for dry or wet pick-up.
CLEANING A WET FILTER
1. After filter (part J) is removed, run water through the filter from a hose or spigot. Take care that water pressure from
the hose is not strong enough to damage the filter.
2. Refer to ''filters assembly'' section of this manual. Allow the filter to dry before reinstalling and storing the vacuum.
CLEANING A DRY FILTER
1. For the best cleaning results due to accumulated dust, clean the filter in an open area. CLEANING SHOULD be
done outdoors and not in the living quarters.
2. Refer to ''filters assembly'' section of this manual to remove the filter (part J) and disposable filter bag (part K).
3. After the disposable filter bag (part K) removal from vacuum, let the dry debris fall down to the garbage can from the
dust bag.
4. After the filter (part J) removal from vacuum, remove the dry debris by gently tapping filter against the inside wall of
your dust tank. The debris will loosen and fall.
5. For thorough cleaning of dry filter with fine dust (no debris), run water through it as described under "Cleaning A Wet
Filter.
CLEANING AND DISINFECTING THE WET/DRY VACUUM
To keep your Wet/Dry Vacuum looking its best, clean the outside with a cloth dampened with warm water and mild soap.
To clean the tank:
1. Dump the debris out.
2. Wash drum thoroughly with warm water and mild soap.
-7-