Blower Function; Accessories - Stanley SL18129 Manual Del Propietário

EMPTY LIQUID WASTE FROM THE TANK
WARNING!
TO REDUCE THE RISK OF INJURY FROM ACCIDENTAL STARTING, UNPLUG POWER CORD BEFORE
EMPTYING THE TANK.
1. The vacuum can be emptied of liquid waste by removing the tank drain cap. To empty, turn unit off and remove plug
from the wall receptacle. Remove the drain cap and deposit the liquid waste contents in a suitable drain. After the
tank is empty, return the drain cap to its original position. （Picture 14）
2. Another option is to remove the power head assembly. Lay power head assembly aside on a clean area.
3. Dump the tank contents into the proper waste disposal container.
WARNING!
TO REDUCE THE RISK OF BACK INJURY OR FALLS, DO NOT LIFT A VACUUM HEAVY WITH LIQUID
OR DEBRIS. SCOOP OR DRAIN ENOUGH CONTENTS OUT TO MAKE THE VACUUM LIGHT ENOUTH TO
LIFT COMFORTABLY.

BLOWER FUNCTION

WARNING!
ALWAYS WEAR SAFETY EYEWEAR COMPLYING WITH ANSI Z87.1 (OR IN CANADA, CSA Z94.3) BEFORE
USING AS BLOWER.
WARNING!
TO REDUCE THE RISK OF INJURY TO BYSTANDERS, KEEP THEM CLEAR OF BLOWING DEBRIS.
ATTENTION!
WEAR A DUST MASK IF BLOWING CREATS DUST WHICH MIGHT BE INHALED.
ATTENTION!
TO REDUCE THE RISK OF HEARING DAMAGE WEAR EAR PROTECTORS WHEN USING THE
VAC/BLOWER FOR EXTENDED HOURS OR WHEN USING IN A NOISY AREA.
1. This vacuum features a blowing port. It can blow sawdust and other debris. Follow the steps below to use your vac
as a blower.
2. Locate blowing port of your vac（Picture 15）.
3. Insert the locking end of the hose (part B) into the blowing port of the vac. The hose should snap into place.
4. To remove the hose from vac, press the release button in the hose assembly and pull the hose out of the vac inlet.
5. (Optional) Attach extension wand to opposite end hose, then place the car nozzle on the wand.
6. Turn vac on and you are ready to use your vac as a blower.

ACCESSORIES

WARNING!
MAKE SURE ALL ASSEMBLY IS ACCORDING TO THIS MANUAL.
ATTENTION!
THE VACUUM IS EQUIPPED WITH THREE NOZZLES FOR DIFFERENT APPLICATIONS. EACH INDIVIDUAL
NOZZLE CAN EITHER BE FITTED ONTO THE EXTENSION WAND OR DIRECTLY ONTO HANDLE OF
FLEXIBLE HOSE.
-6-