Trouble Shooting; Warranty - B.A. International BA Optima E+ Manual De Instrucciones

11. TROUBLE SHOOTING

When trouble is found, check the following before contacting dealer. If none of these are applicable or the trouble is not remedied even after
action has been taken, contact dealer.
Problem
The power of motor handpiece is not
turned on.
The temperature of motor handpiece is high.
The Charging Station does not work.
(The CHARGE lamp does not light.)
The motor handpiece does not rotate
GENERAL MANDATORY
* Clean inside of the product before sterilizing to avoid dirt and blood stuck inside.
* Do not use the product in wrong way and be careful for safety.
* Disassemble the product after stop the product completely.
* Disassemble and/or repair only the case which mentioned in the manual.
* Do not drop the handpiece, it may cause the damage of the product.
* Use the product after inserting the contra angle into the motor handpiece end completely.
* Check if it is normal condition for handpiece operation, especially for vibration, noise, temperature etc.
* Contact Dealer/Manufacturer if problems occur.
* The manufacturer does not have any responsibility for problems that occur after not following the manual.
* Product design and specification can be changed for better quality without advance notification.
* User has a responsibility for use and maintains the product properly.

12. WARRANTY

(Handpiece=1 year/Control Box=1 year)
* The warranty does not cover the damages by user's misuse and normal wear and tear of spare parts.
14
BAE370R_IFU-Final.indd 14
Cause
Battery has been discharged.
Battery has not been inserted.
The temperature of battery is high.
The plug of the Charger is not inserted into
the outlet, or there is no electricity in the
outlet.
Internal fuse has burnt.
Head of Contra angle was stuck.
Bonding of motor gear was detached.
Solution
Charge the battery.
Insert the battery.
It is normal that the batteries become a
little bit warm right after charging. If the
batteries are hot while normal operating
conditions, there may be an abnormality.
Contact dealer.
Check the connections.
Contact dealer.
Clean the head or change it.
Contact dealer.
02/04/2019 12:22:33