Campbell Hausfeld PS460G Manual De Uso página 4

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
● DO NOT place your body near
the spray tip. Keep hands and
other body parts away from the
discharge. For example, DO NOT try
to stop leaks with any part of the
body.
● DO NOT clean spray tip while it is
attached to the spray gun. Remove
spray tip from gun to clean tip
guard.
● ALWAyS use the nozzle tip guard.
DO NOT spray without nozzle tip
guard in place.
● DO NOT remove tip while cleaning
the pump.
● Only use a nozzle tip specified by
the manufacturer.
● Use caution when cleaning and
changing nozzle tips. Before
removing the nozzle tip, follow
the manufacturer's instructions for
turning off the unit and relieving
the pressure.
● DO NOT leave the unit energized or
under pressure while unattended.
When not in use turn off the
unit and relieve the pressure in
accordance with the manufacturer's
instructions.
● Check parts for signs of damage.
Replace any damaged parts.
www.chpower.com
● This spray gun is rated for 3000
psi (20 500 kPa). DO NOT use on
systems designed to produce more
than 3000 psi (20 500 kPa).
● ALWAyS engage the trigger lock
when not spraying. Verify the
trigger lock is functioning properly.
• To lock (engage): rotate tabs on
lock to horizontal position.
• To unlock (disengage) to spray:
rotate tabs on lock to vertical
position.
NOTE: If gun sprays while in the locked
position follow instructions in Spray
Gun Maintenance section for trigger
lock.
● Verify that all connections are
secure before operating. DO NOT
use pliers to tighten or loosen high
pressure connections.
● Know how to stop your unit
and bleed pressure quickly. Be
thoroughly familiar with the
controls.
locKEd To uNlocK
uNlocKEd
4
Before servicing or resting:
1. Turn the Prime/Spray Control to the
PRIME position.
2. Turn the pressure control to LOW
PRESSURE/HyDRAULIC BLEEDING
position.
3. Turn engine off.
4. With gun pointed in a safe direction,
pull the gun trigger, with the
trigger lock disengaged.
5. Engage trigger lock.
● Simply turning off the pump motor
will not relieve pressure from
system. The above procedure MUST
be followed.
FIrE Or EXPLOSION
HAzArD:
● DO NOT operate in
the presence of open
flame or spark. Spray in a well ventilated area
with good air movement
moving through the
spray area.
● DO NOT remove fuel tank cap or
fill fuel tank while engine is hot or
running (allow engine to cool two
minutes before refueling). ALWAyS
fill the tank slowly. Refueling a hot
engine could cause a fire. Use only
fresh, clean unleaded gasoline.
Close the fuel shutoff valve during
refueling.
● DO NOT use solvents with flash points less than 70°F (21°C) to
clean this equipment (examples
of acceptable cleaning solvents
To locK
are water, mineral spirits, lacquer
thinner, Xylene and high flash
napha. A partial example list of
unacceptable cleaning solvents are
low flash napha, mek, acetone,
alcohol and toluene).
● Use only conductive or grounded
high-pressure airless paint sprayer