Campbell Hausfeld PS460G Manual De Uso página 14

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
CLEAN UP FOr CHANGING PAINTS
Or TEMPOrAry STOrAGE FOr
MOrE THAN ONE NIGHT (Continued)
Allow the to continue
cleaning fluid
circulating for approximately 10
minutes.
7. Turn pressure to HIGH (completely
clockwise).
8. Turn prime/spray control to SPRAy/
ROLL position.
9. If reversible tip is used, rotate spray
tip to CLEAN position.
ground the gun
by holding it
against the edge of the metal container
while flushing. Failure to do so coulD
lead to a static electric discharge,
which coulD cause a fire.
10. Point spray gun into bucket of paint
and pull trigger.
NOTE: To reduce splashing, direct
fluid stream along inside of bucket
and above the paint level.
11. As soon as cleaning fluid is flowing
from spray gun, release trigger.
NOTE: It should take less than one
minute to clear each 25 feet of high
pressure hose.
12. Engage gun trigger lock.
13. Turn prime/spray control to PRIME
position.
14. Turn pressure control to HIGH.
15. Lift suction assembly above fluid
level in bucket.
NOTE: Allow pump to run until
empty.
16. Repeat process (1 - 15) with
fresh cleaning fluid, to remove
contaminated cleaning fluid from
initial cleaning.
www.chpower.com
Cleaning Hose and Gun
7
Turn Pressure to HIGH
(completely clockwise).
10
Paint
While Pulling Trigger,
Direct Fluid Stream Along
Inside of Bucket
13
PRIME Position
14 14
8
Turn Prime/ Spray
Control to SPRAy (knob
is horizontal)
12
To lock
Engage Gun Trigger Lock
15
14
HIGH PRESSURE Position
(completely clockwise)
9
If Reversible Tip is
Used, Rotate Spray Tip
to CLEAN Position.
locked
Lift Suction
Assembly