Problem solving for programmed
recordings
PROBLEM
DVD Recorder does not
respond
'Switch off, timer recording'
flashes on the TV screen.
Error message: 'Insert
recordable disc'
The error message 'Disc
locked' appears briefly on
the screen.
Error message: 'Memory
full'
The 'Data error' message
appears on the screen.
The message 'Collision'
appears on the screen.
68
SOLUTION
b
While a programmed recording is being made, you cannot operate your DVD Recorder
manually. If you want to cancel the programmed recording, press STANDBY m .
b
The DVD Recorder was switched on a few minutes before the start of a programmed
recording.
Turn off the DVD Recorder by pressing STANDBY m . A programmed recording (timer)
will only function if the DVD Recorder is switched off (button STANDBY m ).
b
Either no disc was inserted or a disc was inserted that cannot be used for recordings. Insert a
disc that can be recorded upon.
Locate on the disc the right position for the recording.
Turn off the DVD Recorder by pressing STANDBY m .
b
A protected disc was inserted. Undo the erase protection (chapter 'Manual recording', section
'Preventing accidental erasing of discs '), or insert a different disc.
b
If this error message appears after pressing TIMER , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. Select the
programmed recording (TIMER block) you want to check or clear using CH+ A or CH- B .
b
The data for the recording could not be transferred. Please check date, start time, and end
time of the programmed recording.
b
The timer recording overlaps with another timer recording.
b
If you ignore this warning, the programmed recording with the early start time will start first.
The second recording will then lack the beginning.
b
Change the information for one of the two recordings.
b
Delete one of the two recordings.
Programming a recording (TIMER)