Useful Information - Atlas Copco PRO D2148-RQ Instrucciones De Producto

D2148-RQ
e.g. supplied from a fog lubricator (DIM) or Dosol
system.
This does not apply to turbine tools, which should
be kept oil free.
Compressed air connection
• The machine is designed for a working pressure
(e) of 6–7 bar = 600–700 kPa = 87–102 psi.
• Blow out the hose before connecting.
Maintenance
Rust protection and internal cleaning
Water in the compressed air, dust and wear particles
cause rust and sticking of vanes, valves etc.
This can be prevented by flushing with oil (some
drops), running the tool for 5–10 seconds and absorb-
ing the oil in a cloth. Protect the tool this way before
longer standstills.
Overhaul and lubrication
The tool should be checked regularly at six-monthly
intervals. If it is in heavy duty service or not running
properly, it should be taken out of service more often
for inspection.
Regarding instruction for dismantling and as-
sembly, see separate Service Manual.
The throttle valve, planetary gears, needle bearings
and ball bearings must be lubricated with grease
when the tool is dismantled for the regular overhauls.
Molykote BR2 Plus gives long intervals between
lubrications.
A Clean the motor parts and apply a thin layer
of gleitmo 585 KC grease (180 g – Ordering
No. 4080 0871 80) onto the vanes and inner
surface of cylinder and end plates.
Assemble the motor and check that it is run-
ning free. Add two drops of oil through the
air inlet and run the motor (machine) at idling
speed for 5-10 seconds.
The strainer in the adapter should be cleaned regu-
larly to prevent choking with resultant decrease in
capacity
Lubricating guide for Grinder/ Sander
(except turbine) and Drill
Brand
BP
Castrol
Esso
Q8
Mobil
Shell
Texaco
Molycote

Useful information

You can find all kind of information concerning Pro
products, accessories, spare parts, published matters
on our WEB site!
C Log in to www.pro-powertools.com
Technical data
Noise and vibration emission
Noise (according to PN8NTC 1.2)
Measured sound pressure level
Determined sound power level
Spread in method and production
Vibration (according to ISO 8662-1)
Measured vibration value
Spread in method and production
Declaration of noise and vibration emis-
sion
These declared values were obtained by laboratory
type testing in compliance with the stated standards
and are not adequate for use in risk assessments.
Values measured in individual work places may be
higher than the declared values. The actual exposure
values and risk of harm experienced by an individual
user are unique and depend upon the way the user
works, the workpiece and the workstation design, as
well as upon the exposure time and the physical
condition of the user.
We, Atlas Copco Tools AB, cannot be held liable
for the consequences of using the declared values,
instead of values reflecting the actual exposure, in
an individual risk assessment in a work place situ-
ation over which we have no control.
© Atlas Copco Tools - 9836 4060 00
Safety and operating instructions
General purpose
Bearings
Energrease LS-EP2
Spheerol EP L2
Beacon EP2
Rembrandt EP2
Mobilegrease XHP 222
Alvania EP2
Multifak EP2
BR2 Plus
Air lubrication
Energol E46
Arox EP46
Chopin 46
Almo oil 525
Tonna R32
Aries 32
See "Lubrication" in
Operating instruc-
tions
dB(A)
77
-
3
2
m/s
< 2.5
-
5