Mma Process; Tig Process - Cebora SOUND MIG MIG 3540/T STAR PULSE Manual De Instrucciones

Note: it is possible to weld within the double pulse functions.
Once these adjustments have been made, to return to the
control panel normal display briefly press key AE.
Should it be necessary to adjust the arc length of the low-
est current/lowest speed, adjust the arc length of the ref-
erence speed. When the reference speed moves, the pre-
vious settings must also be repeated for the new speed.
12- Ito. (Inching time out.
The purpose is to stop the welding machine if the wire
flows after starting with no passage of current.
The wire flow from the welding torch can be adjusted
from 5 to 50 centimeters by means of knob AN. When this
function is restored, it may be activated (On) or cut off
(Off).
13- Fac. (factory).
The purpose is to return the welding machine to the orig-
inal settings provided by the manufacturer. With the func-
tion selected, the display AM shows noP = restores the
welding machine to the original settings disregarding the
stored programs, Prg = deletes all stored programs and
ALL = restores the welding machine to the original set-
tings.
To save the desired function press the button AV, the
abbreviation shown on the display AM will begin flashing;
after a few seconds, a sound will confirm that it has been
saved.

5.2. TIG PROCESS

1- H2o (Cooling assembly OPTIONAL Art. 1683.
See point 1 of MIG process paragraph.
2- TRG.
See point 2 of MIG process paragraph.
The difference concerns the 3L and how the welding but-
ton is pressed.
Welding starts when the welding button is pressed and
immediately released, the recalled current will be the
starting current SC.
This current is kept until the welding button is pressed
and released; at this time the original current connects
to the wedding current, set by means of knob AI.
When the welding torch button is pressed and released
again, the welding current connects to the thrid current
CrC and is kept activated until the welding torch button is
pressed and released again; now welding is interrupted.
3- SLd (Slop Down).
Possibility of adjusting from 0 to 10 seconds.
Defines the current slope down time from the welding
value to the arc shutdown.
4- PrF (Pre-gas).
See point 6 of MIG process paragraph.
5- Pof (post-gas).
See point 7 of MIG process paragraph.
6- Fac. (factory).
See point 13 of MIG process paragraph.

5.3. MMA PROCESS

1. HS (Hot Start).
You may adjust from 0 to 100%.
Adjusts the overcurrent dispensed at the arcing ignition,
value adjusted by means of knob L.
2- LED AF – (Arc-force).
You may adjust from 0 to 100%.
Adjusts the dynamic characteristic of the arc, a value
adjusted using the knob AN.
3- Fac. (factory).
See point 13 of MIG process paragraph.
6 INSTALLATION
The welding machine must be installed by skilled per-
sonnel. All connections must be made in full compliance
with current safety laws.
6.1 PLACEMENT
The weight of the welding machine is approximately 80
Kg therefore for lifting it see Fig.4.
Fig. 4
Position the unit in an area that ensures good stability,
and efficient ventilation so as to prevent metal dust
(grinding) from entering.
6.2 ASSEMBLY
Mount the rear wheels.
Mount the plug on the power cord, being especially care-
ful to connect the yellow/green conductor to the earth
17