Tabla de contenido
7.6 Initial pellet loading
Enter menu 6, then press button 2. The exhaust fan will turn on and the auger starts to turn. A 90 seconds
count-down will appear on the display. The initial pellet loading stops automatically after the 90 seconds. If
necessary, it can be stopped before by pressing button 3. This function is available only when the stove is
switched OFF. Upon the first stove start-up the auger tube must be loaded with pellets.
If the pellet container runs completely empty during use, it is necessary to load the auger as described
above. Stop the initial pellet loading as soon as you can hear/see pellets falling into the brazier.
7.7 Information on the operation of the stove
When entering menu 7, you can scroll through a few parameters on the display. The table below contains an
example of the values shown on the display together with their meaning.
Displayed status (example) meaning
3.1"
52'
Toff
106°
1490
7.8 Technical settings
IMPORTANT!
Menu 08 is reserved only for authorised service partners. Any change in the parameters that was made by
unauthorized persons will result in the loss of warranty!
Auger/Pellet loading status
Max. time for ignition phase
Thermostat status
Smoke temperature
Exhaust fan speed
56
Tabla de contenido
