Tabla de contenido
The display shows basic information about the operation of the stove and has 3 buttons for various settings
(see the description below).
Room temperature setting LED
Heat output setting LED
Button 2: increase/stove
status/heat output setting
Button 1: decrease/menu/room
temperature setting
Make sure the stove is connected to the power source and the chimney.
6.1 Turning the stove on and off
To turn on the stove, press and hold button 3. The ON/OFF LED starts flashing.
During the pre-heating phase, the igniter and the exhaust fan start to work, indicated by the respective LED
on the display. After approximately 1 minute, the auger starts to turn and transport pellets into the brazier.
Once the needed smoke temperature is reached, the stove enters the fire-on phase and the igniter turns off.
When the smoke temperature remains above the minimum for a certain period, the stove will enter the
normal operation phase. This is indicated by the ON/OFF LED shining permanently.
Now, the heat level and the room temperature can be changed according to the instructions under section
6.2.
From time to time, the stove will clean the brazier by reducing the auger speed and increasing the exhaust
fan speed. The stove automatically returns to the normal operation phase.
5. Display
Auger LED
Exchanger LED (inactive)
Igniter LED
6. Using the stove
Button 3: ON/OFF/confirm/exit
Display: Current status/parameters
Timer LED
Alarm LED
ON/OFF LED
51
Tabla de contenido
