Performing The N1100-On Series Initial Configuration; Enabling Remote Management - Dell N1108T-ON Guía De Introducción

Performing the N1100-ON Series Initial
Configuration
The initial configuration procedure is based on the following assumptions:
• The Dell Networking switch was never configured before.
• The Dell Networking switch booted successfully.
• The console connection was established, and the Dell Easy Setup Wizard
prompt appears on the screen of a PC running terminal emulation
software.
The initial switch configuration is performed through the console port. After
the initial configuration, you can manage the switch from the already-connected
console port or remotely through an interface defined during the initial
configuration.
NOTE:
The switch is not configured with a default user name, password, or
IP address.
Before setting up the initial configuration of the switch, obtain the following
information from your network administrator:
• The IP address to be assigned to the management interface.
• The IP subnet mask for the network.
• The IP address of the management interface default gateway.
These settings are necessary to allow the remote management of the switch
through Telnet (Telnet client) or HTTP (Web browser).

Enabling Remote Management

On the N1100-ON Series switches, you can use any of the switch ports on the
front panel for in-band management. By default, all in-band ports are
members of VLAN 1.
The Dell Easy Setup Wizard includes prompts to configure network
information for the VLAN 1 interface on the N1100-ON Series switches.
You can assign a static IP address and subnet mask or enable DHCP and
allow a network DHCP server to assign the information.
Refer to the CLI Reference Guide for commands to configure network
information.
Getting Started Guide
19