Nice IT4WIFI Instrucciones Y Advertencias Para La Instalación Y El Uso página 6

4.2 - Initial set-up with MyNice (Android) technology
To run the procedure, the person must be near the IT4WIFI device, led L3 must be lit steady green and led L2 ashing green. Should this not be the case, run the Reset procedure
(Chapter 5). Moreover, ensure that the smartphone is connected to a Wi-Fi network that supports the Bonjour service.
Table 3 - Smartphone with Android 5
operating system and later versions
01. Open the "MyNice Wel-
come" app and select
Start with your first Nice
Accessory"
02.
After entering the values
requested by the app (User
name, Description, Home),
select "Add new acces-
sory..."
03. After the Wi-Fi networks
have been scanned, select
the "NiceIT4WIFIxxxxxx"
name to be configured:
xxxxxx denote the last 6
characters of the MAC
appearing on the IT4WIFI
label.
Select the arrow on the top
right-hand side to proceed
5 – English
04. Enter the credentials of
the network to which the
accessory must be con-
nected.
It is important to carefully
check that the parameters
have been entered cor-
rectly.
After selecting the arrow
on the top right-hand side,
wait roughly 2 minutes for
the procedure to terminate
05. Once the procedure termi-
nates, wait for the acces-
sory to appear in the app
among the Wi-Fi network
accessories in which it was
configured and wait for leds
L1 and L3 to turn steady
green (led L2 may remain
orange if the device cannot
be reached remotely).
Subsequently, select it to
proceed
06. Enter the code stamped on
the IT4WIFI label and select
the arrow on the top right-
hand side to complete the
set-up procedure
07. Once the set-up termi-
nates, to control the auto-
mation connected to the
IT4WIFI device, select the
"Open", "Stop" and "Close"
buttons. The change of sta-
tus of the automation can
be viewed on the icon.
Selecting the "eye" sym-
bol allows for using all the
other additional movement
controls
If the procedure described does not terminate
successfully, check that the requirements indicated
at the beginning of the manual are satisfied, run the
IT4WIFI reset procedure using the P button (Chapter
5) then try again.