Introduction; Parts List; General Specifications; Machine Capacity - Alpine ALS 4.0 Manual De Instrucciones

1. Introduction

1.1

Parts List

 Suggested Stocking Parts:
• Emitter 23141
• Receiver 24679
• Door Switch 38207
• Door Switch Key 38208
• Module E-Stop 25990
• Lumber Present Sensor (Infeed) 24664
• Lumber Present Sensor (Printer) 20661
• SMC Valves Solenoid 36758
 Common Wear Parts:
• Belt L1 & L2 29107
• Blade Kit 35127
Includes: Blade
Screws
Nyloc Nut
Torx Bit
 Motion Control Components:
• Servo Drive 3 amp 29119
• Servo Drive 6 amp 29118
• Servo Drive 12 amp 29156
• Servo Motor 3 amp 29103
• Servo Motor 6 amp 29102
• Servo Motor 12 amp 38007
• Blade Motor Mitsubishi 38454
• Blade Motor Drive Mitsubishi 38455
• Blade Motor Power Cable Mitsubishi 38471
• Blade Motor Feedback Cable Mitsubishi 38472
• Power Cable S200 29155
• Feedback Cable S200 29132
• ZMP Controller 37146
• Slice I/O Module 29121
 Quick Reference:
• Computer 38162
• Belt B1& A1 28979
• Small parts VFD 37069
• Safety Sticker Set 35194
All parts can be conveniently ordered from
our website. Visit: shop.alpineitw.com
Or email your order to [email protected]
1.2

General Specifications

1.2.1

Machine Capacity

 Lumber Size Range
Min
Width 2.38" (64mm)
Thickness 1.38" (35mm)
Length 6" (152mm)
 Cut Types:
• Chords
• Webs
• Scissor bottom chords
• Wedges
• Sliders
• Single and double beveled ends
(if saw is equipped with optional bevel axis)
• Ripped valley bottom chords
(if saw is equipped with optional bevel axis)
• Floor truss webs
(if saw is equipped with optional bevel axis)
 Pieces:
• Minimum: 1" (25mm) for all pieces with four
angle cuts
• Maximum Recommended Scarf: 104 inches at
8 degrees
Throughout this manual, references
are made to contact Alpine Equipment
Customer Service. They can be reached at
800-521-9790 with any questions.
Disclaimer
The information contained in this document is believed to be accurate in all
respects but is not warranted by Alpine. The information is subject to change
without notice and should not be construed in any way as a commitment by
Alpine. Alpine assumes no responsibility for any errors or omissions in this
document. Every reasonable effort is made to keep this document current, but
in the event of discrepancy, Alpine engineering documentation, installation
and service and safety procedures shall prevail.
Copyright ©2015 by Alpine, a division of ITW Building Components Group Inc.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system,
or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise, without the prior written consent of
the publisher.
4
EN
ALS 4.0
P R O D U C T M A N UA L
Max
14" (355mm)
1.77" (45mm)
24' (without additional support)