Application Area; Ambient Conditions; Hazard Information - Renfert MT 2 Instrucciones Para El Servicio

ENGLISH
1. Introduction
We are pleased with your decision to purchase the
MT2 - Trimmer which sets new standards with
respect to function, performance, safety, and styling.
DSS Disc Stop System:
This trimmer is equipped with a maintenance-free
electronic motor brake. After the unit is switched off or
if the front cover is opened, the trimmer disc is stop-
ped within 5 seconds. The resulting buzzing sound
emanating from the motor area is perfectly normal.
Please read the following operating
instructions carefully and observe all the
information they contain in order to
ensure long and trouble-free service.

2. Application Area

The MT2 is a wet trimmer used for grinding plaster or
acrylic models for dental technology applications.

2.1 Ambient Conditions

(in accordance with DIN EN 61010-1)
The unit may only be operated:
• indoors;
• up to an altitude of 2,000 m [6,500 ft] above sea
level;
• at an ambient temperature range of 5 - 40ºC
[41 - 104ºF] *);
• at a maximum relative humidity of 80% at 31ºC
[87.8ºF], dropping linearly to 50% relative humidity at 40ºC [104ºF] *);
• with a mains power supply whose voltage fluctua-
tions do not exceed 10% of the rated value;
• under contamination level 2 conditions;
• under over-voltage category II conditions.
*) Between 5 - 30ºC [41 - 86ºF] the unit can be operated at a
relative humidity of up to 80%. At temperatures between
31 - 40ºC [87.8 - 104ºF] the humidity must decrease
proportionally in order to ensure proper operability (e.g., at 35ºC
[95ºF] = 65% relative humidity, at 40ºC [104ºF] = 50% relative
humidity). The unit may not be operated at temperatures above
40ºC [104ºF].

3. Hazard Information

3.1 Employed Symbols
The following symbols are used in these instructions
and on the unit:
Danger
This indicates an imminent risk of injury.
MT2 Trimmer
Nr. 1801-0000
3.2 Hazard Information
During trimming, please observe the accident preven-
tion regulations of the relevant professional associati-
on as well as the following safety information:
• The MT2 is an electrical device with inherent
• The unit may only be connected to a properly
• Prior to commissioning, compare the
• Never touch the trimmer disc while the unit is
• Never wear loose clothing when working with
• The unit is only designed to grind plaster or
• Never open the front cover while the motor is
- 1 -
Electrical hazard
There is a risk of electrical shock.
Attention
Failure to observe the associated informa-
tion can result in damage to the unit.
Note
The operating instructions contain useful
information to make handling easier.
Wear eye protection.
For indoor use only.
Before opening the unit, disconnect it
from the mains power supply by pulling
the wall plug.
Note the operating instructions.
hazard potential. This device may only
be installed and operated by authorized
specialists after examination of compliance
with locally applicable standards.
grounded power supply.
voltage information on the nameplate with
the specifications of the local mains power
network.
connected to the mains power supply. Serious
injury could result should the unit accidentally
start!
the trimmer and always tie long hair up or back.
Clothing or hair may become tangled or wound
up in the unit.
acrylic.
running. The motor automatically switches off
if the front cover is opened, but the disc will
continue to spin for approx. 5 seconds.
EN