Application Area; Ambient Conditions; Safety Information; Symbols Used - Renfert Vario E Instrucciones De Servicio

ENGLISH
1. Introduction
We are pleased with your decision to pur-
chase a Vario E wax heating unit.Please
observe the following information in order
to ensure long and trouble-free service.

2. Application Area

The Vario E wax warmer heats wax in
three independently adjustable pots.
2.1 For modelling waxes
Depending on the adjusted temperature,
small or large wax portions can be taken
up out of the pots either directly with the
electric modelling instrument or after the
instrument has been heated over the
flame. This prevents strong contractions
since the waxes are not subject to strong
temperature fluctuations. This ensures
that a uniform quality is maintained.
Technicians can therefore model efficiently
and rationally with a uniform wax consis-
tency.
2.2 For dipping waxes
It is also possible to use the Vario E as a
wax dipping pot. Thanks to its 14.5 mm
(0.57 inch) deep wells, the unit offers ideal
conditions.
2.3 For light-curing waxes
With a temperature interval of
45 - 110 °C (113 - 230 °F) the Vario E
is particularly suitable for processing
light-curing waxes.

2.4 Ambient Conditions

(in accordance with IEC 60664-1)
The Vario E may only be operated:
• Indoors;
• Up to an altitude of 2,000 m
(6,500 ft) above sea level;
Vario E
No. 1452-0000 / No. 1452-1000
• At an ambient temperature of
5 – 40 °C (41 – 104 °F);
• At a maximum relative humidity of 80 %
at 31°C (87.8 °F), decreasing linearly to
50 % relative humidity at 40 °C (104 °F);
• At mains power fluctuations where the
voltage fluctuations do not exceed 10 %
of the nominal value;
• At pollution degree 2;
• Over voltage category II

3. Safety Information

3.1 Symbols Used

The following symbols are employed in
these instructions and on the unit:
Danger
An imminent danger of injury
exists.
Electrical Power
Danger of electrical shock
Attention
Failure to observe this informa-
tion can result in damage to the
unit.
Note
This is a note intended to pro-
vide the operator with useful
information to make operation
easier.
For indoor use only.
Before opening the unit, discon-
nect it from the power supply by
pulling the wall plug.
- 1 - EN