KRATOS SAFETY KS 8000 Guia De Instalacion página 12

Anticaída deslizante sobre línea de anclaje en raíl

página de 32

/ 32
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

1.4 MOUNTING BRACKET (FA 20 706 00) –

This bracket is used to affix the rail system to the receiving structure (concrete wall or metal surface) - see Fig. 4. The receiving structure must be drilled

so that the mounting bracket can be affixed with 16 mm fastenings.

This gives the rail greater stability.

Fastenings: 1 Hex Head Bolt (provided).

weight : 1,16 kg.

Hex Head Bolt

Material: 316 stainless steel

Tools needed: 17 mm spanner wrench.

Installation : Install two mounting brackets per rail.

• The mounting bracket (FA 20 706 00) can be installed on different receiving structures (metal, concrete, etc.) with specific fasteners.

• Chemical fixation must be used to install the mounting bracket on concrete (not provided).

• For metal structures, stainless steel fasteners must be used (not provided).

• The shorter end of the mounting bracket is affixed to the rail with a fastening nut (see §1.1). The longer end is affixed to the receiving structure

with a suitable fastener (Fig. 4).

1.5 RUNG CLAMP (FA 20 705 00) –

The aluminium rail is installed directly onto the rungs of a ladder using mounting accessories.

The rung clamp helps hold the aluminium rail against the ladder rungs.

Weight: 1.16 kg

Material: 316 stainless steel

Tools needed: 17 mm spanner wrench.

Installation: Install two rung clamps per rail.

• Insert the T screws into the aluminium rail and slide them to the point where the counterplate will be mounted.

• Make sure that the first counterplate is about 30 cm from the lower edge of the rail.

• Place the T screws on each side of the rung.

• Behind the rung, place the counterplate with separator on the T screws (Fig. 5).