Complete The Installation - Kohler K-6228 Guía De Instalación Y Cuidado

7.

Complete the Installation

Setscrew
Vis de retenue
Tornillo de fijación
Sprayhead
Tête de vaporisateur
Cabeza del rociador
NOTE: The spray must be removed and the lines flushed or debris may block the
water flow.
Remove the button cover from the spray assembly.
Push the button on the sprayhead in while sliding the tube down from the spout.
The setscrew will be visible.
Loosen the setscrew on the spout until the sprayhead releases from the spout.
Open the valves and run water through the spout for about a minute to remove
any debris. Check for leaks.
Check that the setscrew will not interfere with the sprayhead. If the setscrew
protrudes into the area the sprayhead will be inserted, loosen it until it is flush or
behind the interior surface of the spout.
Align the groove at the top of the tube with the pin on the end of the spout.
Slide the tube up until it stops and hold it in place.
While holding the tube up, push the sprayhead into the spout.
Retighten the setscrew.
Slide the tube up and reinstall the button cover.
Check the button for correct operation.
Kohler Co.
Button Cover
Cache-bouton
Tapa de botón
19 1095311-2-G