Sensor Diagnostics Menu; Sensor Setup Menu; English - Hach AN-ISE SC Manual Del Usuario

Section 4

4.1 Sensor diagnostics menu

SENSOR STATUS
AN-ISE sc or AISE sc or NISE sc
Error list
Warning list

4.2 Sensor setup menu

SELECT AN-ISE sc or AISE sc or NISE sc (if more than one sensor or analyzer is attached)
Calibration
Matrix correction
None
1-point matrix correction
1
NH + NO
4 3
1,2
NH
4
1,3
NO
3
1,2
NH + K
4
1,3
NO + Cl
3
1
NH +K + NO +Cl
4 3
Take the grab sample
immediately for the lab
analysis.
1-point value correction
1
NH –N
4
1
NO –N
3
Enter the values for the
first point

English

Operation
For more information on System Setup (current outputs, relays, and
network interfaces), refer to the sc1500 User Manual.
The following tables show the sensor menu for the AN-ISE sc
probe, AISE sc probe and NISE sc probe. If a menu item does not
apply to all three probes, its applicability is explained in footnotes.
Footnote
AN-ISE sc probe is used to determine the ammonium and nitrate
concentration, as well as the potassium and chloride concentration.
Footnote
probe is used to determine the ammonium and potassium
concentration.
Footnote
probe is used to determine the nitrate concentration and chloride
concentration.
Shows all current error messages.
Shows all current warnings.
Matrix correction options.
The most recently used menu is displayed.
The currently active corrections are shown in Information.
No Matrix corrections activated
1-point matrix correction
1-point matrix correction for ammonium and nitrate
1-point matrix correction for ammonium
1-point matrix correction for nitrate
1-point matrix correction for ammonium and potassium
1-point matrix correction for nitrate and chloride
1-point matrix correction for ammonium, potassium, nitrate and chloride
Information window: When this window appears, the sample must be taken immediately
and then analyzed in the laboratory.
Perform 1-point value correction.
The most recently used menu is displayed.
The currently active corrections are shown in Information.
Select parameter for the 1-point value correction
Enter the values for the 1-point value correction
Note: The following example shows the input when using a AN-ISE sc probe for
ammonium. When using the AISE sc probe, the input is the same. When using the
NISE sc, it is only possible to input the nitrate and chloride values.
indicates applicability to the AN-ISE sc probe. The
1
indicates applicability to the AISE sc probe. The AISE sc
2
indicates applicability to the NISE sc probe. The NISE sc
3
English
5