Probuilder 66270 Manual De Instrucciones página 54

Dismantling
How to dismantle the plasterboard lift for
transport and storage:
1. Lower the cradle fully.
2. Push the outriggers in fully until they
engage. Fold the support hooks in.
3. Detach the support arms from the
cradle by pressing the lock tab at the
bottom and pulling the support arms
out of the tapered sockets.
Press the lock tab in to
release the support arm
4. Release the clip for the tilt function. Lift
the cradle about 7.5 cm until you can
remove it from the frame.
5. Turn the handle forward one full
revolution as shown. This lifts the inner
telescopic section.
6. Release the hoist by lifting the lock arm
with your left hand and turning the lock
arm's lock anticlockwise with your right
hand.
54
7. Hold the lock arm's lock in the released
position (step 6), and push the
telescopic sections down into the frame
using your left hand. The hoist is now
pulled towards the frame.
8. Lower the telescopic sections fully. Flip
the lock hook up and turn the telescopic
sections up slightly until they are held
by the lock hook.
9. Hold the lock hook in this position with
your left hand and turn the handwheel
forward with your right hand. The hoist
is pressed forward towards the frame.
When the lock arm touches the
frame, tighten the wire by turning the
handwheel slightly (just enough to hold
the hoist in that position).