Probuilder 66270 Manual De Instrucciones página 51

Clip for tilt
Flip the clip out and down to tilt the cradle
(to apply covering boards or lifting covering
boards for sloping walls or ceilings) or to
remove the cradle. You can secure the
cradle on the frame without tilt by � ipping
the clip up so that it engages with the lock
pin on the cradle.
Note! When the cradle is in the horizontal
position (not tilted), the cradle can tilt up to
+/- 10 degrees.
Clip for tilt
Brake lever
A spring-loaded brake holds the cradle
securely at the required height by locking
the hoist's handwheel. When lowering the
cradle, control the rotation of the hoist by
holding the handwheel as you carefully lift
the brake lever to release the brake.
Handwheel, handle and strut
When turning the hoist's handwheel, the
wire will wind in or out and thus raise or
lower the cradle.
Hold the strut to provide resistance as you
turn the handwheel.
Handle
Lock pin
Lock hook
The lock hook secures the telescopic
sections inside the frame for transport and
storage.
Brake lever
Strut
Handwheel Handwheel
Lock hook
GB
51