Operating Parts - Probuilder 66270 Manual De Instrucciones

WARNING! In order to avoid an accident,
the lock arm must be fully engaged
when the hoist is pulled out.
6. Attach the cradle to the frame (� gure 6):
6
Flip the clip up to
secure the cradle
a. Insert the cradle strut into the opening
at the top of the frame.
b. Secure the cradle to the frame by
pressing the clip up over the lock pin so
that it clamps the cradle tight.
7. Attach the support arms to the cradle:
NOTE! The support arms are identical.
a. Push the tapered plates on the support
arms into the tapered sockets on the
cradle. (See � gure 7).
7
Viewed from
above
b. Push both support arms into the sockets
8
Lock tab Lock tab
Lock pin

Operating parts

Lock ring
Press the lock ring down to release the two
front legs so that they can be rotated out
to the working position or in to the storage
position. A spring-loaded tab engages with
a hole at the bottom of the tube to lock the
legs in position.
Reverse brake
Reverse brake
Flip the reverse brake down to prevent the
base from rolling backwards or � ip it up to
allow it to move freely.
until the lock tab at the bottom of each
support arm engages. (See � gure 8).
Lock ring
GB
49