Probuilder 66270 Manual De Instrucciones página 52

Use
IMPORTANT! Read the section 'Special safety
instructions' before using the plasterboard
lift.
WARNING! ALWAYS wear a helmet when
using the plasterboard lift.
WARNING! Only use the plasterboard lift for
lifting covering boards. Only lift ONE board
at a time!
Safety check before use
Each working day, perform the following
checks before using the plasterboard lift:
• Inspect the plasterboard lift thoroughly
for wear and tear. Pay particular
attention to the condition of the wire.
• Make sure the plasterboard lift has
reached room temperature before use.
• Check that the brake drum is clean and
dry.
Loading a covering board
1. Flip the reverse brake down so that
the plasterboard lift does not roll
backwards.
2. Flip the support hooks on the support
arms out. Make sure that the cradle is
turned so that the support hooks are
furthest away from the handwheel.
3. Pull the outriggers on the support arms
out so that they can provide optimum
support for the covering boards.
52
4. Release the clip so that the cradle can
tilt.
5. Hold the covering board against the
tilted cradle with the outer side facing
down. Lower the covering board onto
the support hooks and lay it carefully
against the support arms.
6. If the covering board is to be mounted
on a � at ceiling, tip the cradle up to the
horizontal position and tighten the clip
so that the cradle does not tilt. If the
covering board is to be installed on a
sloping wall or a sloping ceiling, the
cradle should remain tilted.
7. Lift the reverse brake on the base and
carefully roll the plasterboard lift to the
spot where the covering board is to be
installed.