User Operations - GBC eWire Manual De Instrucciones

7. USER OPERATIONS

A. Removing Supply Spool from the Machine:
Supply spools can be removed from the machine before they are
empty to be stored for future use.
B. Installing a New Supply Spool into the Machine:
eWire™ offers a variety of different twin loop wire options, allowing
you to choose the right option for your job. Load a new supply spool
if a different size or color of binding is required, or when the spool
is empty.
C. Supply Spool Storage:
The twin loop wire supply spools should always be stored according
to the guidelines listed to prevent damage.
D. Emptying the Book Drawer:
Empty the book drawer to remove your bound books.
E. Clearing Jams:
How to clear paper or wire jams.
F. Wire Seem Location:
How to order sheets to control wire seem location.
A. Removing Supply Spool from the Machine:
WARNING: POSSIBLE PINCH POINT HAZARD. WHEN
INSTALLING OR REMOVING SUPPLY SPOOLS IN YOUR
EWIRE™, ALWAYS KEEP FINGERS AND OTHER BODY
AWAY FROM MOVING PARTS AND SHARP EDGES.
FAILURE TO FOLLOW THESE PRECAUTIONS MAY
RESULT IN INJURY.
When prompted to replace the spool, opening and closing the
element door will remove this message. It is recommended to
replace the spool immediately when this message appears to
prevent a jam condition.
Step 1: Stop the printer/copier.
Step 2: Open the Element
Feeder Door
Step 3: Slide the feeder drawer
out from the machine by pulling
on the handle.
Step 4: Turn the
counterclockwise to release the
wire loose end from the Element
Feeder.
Note: If the wire end is past the
knife area, cut the excess before
turning the knob. Refer to section
7 E Area 3a
Step 5: Lift slack wire from the
metal wire guide surface and
place it against the magnetic
catch. This will hold wire out of
the way during replacement.
Step 6: Turn the rewind spool
counterclockwise to generate
slack in the carrier paper.
Step 7: Lift the metal wire guide
on the shield and pull the carrier
paper out from the shield.
7
eWire™
ro
Knob
GB