User Display - GBC eWire Manual De Instrucciones

8. USER DISPLAY

Located on the front of the eWire™ is a user interactive LCD panel that
provides Messages, Settings and Information relating to the functions of
the binder.
Messages on the LCD Panel
1. Ready Bypass
eWire™ is ready to bypass, sheets will pass through the machine.
2. Ready to Bind
eWire™ is ready to process a binding job, all sheets through the
unit will be stacked and bound.
3. Running Bypass
This message will be displayed when Bypass mode is in operation.
4. Running Binding
This is displayed when Bind mode is in operation.
5. Book Tray Full
When the book tray is full or near full, the Tray Full message will be
shown.
6. Close Tray
When the book tray is removed or not fully inserted into the eWire™
unit, this message will be displayed.
7. Close Door
When the Front door is open or not completely closed this message
will be displayed.
8. Close Cover
When the top cover is open or not completely closed this message
will be displayed.
9. Add Elements
When the supply of elements is low, or the spool is missing, the add
elements message is displayed.
10. Paused
When there is a non-eWire™ stoppage in the line of equipment this
message will be displayed.
11. Jam Code
The jam code will appear when there is a jam in the machine
along with the area the jam is located. Refer to Section 7 B for
instructions on clearing jams and Section 11 for details on each
jam
LCD User interface screen overview
Changing the Settings on the LCD panel
The User Interface is navigated using the Up and Down arrows next
to the LCD. To change any setting below press OK while it is on the
display and use the arrows to change the setting. After changing
any setting press OK and exit the settings mode
1. Paper Size
Use this option to select between paper sizes.
2. Closing
Use this option to change the closing depth for the twin loop
wire. Offset from -5 to +5 is available and will apply only to the
wire size selected. Use this option to correct for binding that is
over- or under-closed. Refer to Section 9 C for more
details.
3. Alignment
Use this option to correct for sheet offset coming into the eWire
Pro. Refer to Section 9 C for more details.
4. Deflector
Use this option to correct for the timing of the deflector. Refer
to Section 9 C for more details.
5. Language
Use this option to change the language displayed on the LCD
screen.
Displaying Information on the LCD Panel
1. Wire Size
Displays the wire size currently selected. Also shown on the
home screen.
2. Counts
Displays the number of books and sheets that have been
processed by the eWire™.
3. Firmware
This displays the current level of firmware of eWire™.
9
eWire™
ro
GB