GBC eWire Manual De Instrucciones página 10

Step 13: Lift the metal guide of
the shield and slide the carrier
paper between it and the lower
bars.
Step 14: Attach the loose end of
the support paper to the paper
feed hub. Secure the paper to the
hub via the metal clip.
Step 15: Turn the rewind spool
clockwise until you have enough
wire to reach the blue wire guide.
Slide the wire onto the plastic
wire guide and feed it into the
plastic sprocket. Use the knob to
manually turn the plastic
sprocket and aid wire installation.
Step 16: Adjust the wire end
position by using the knob
attached to the wire feed
sprocket. The wire end should
line up in the window on the
blade guard. The wire end
should line up with the transition
line between the blue wire guide
and the grey anvil.
Step 17: Proper installation of
the spool is shown. Wire loose
end is fed around the guide and
positioned properly on the wire
feed sprocket. Paper loose end
is secured to the paper feed hub.
Once installed properly, rotate
the paper rewind spool clock-
wise until the wire makes contact
with the sensor flap under the
spool.
Step 18: Slide the wire feeder
drawer back into the machine.
Step 19: Close the wire feeder
door.
Post Spool Installation Review:
Confirm all the following:

Is the spool secured to the Element Feeder by the holder cap,
with the circular bar code facing in as shown in Section 7 B
Step 9?

Is the wire fed onto the Element Feeder track, with the end
located just before the knife as shown in Section 7 B Step 16?

Is the wire shield in place, with one row of wire resting loosely
on top of it?

Is there one row slack wire below the spool?

Is the end of the paper feed secured to the rewind hub as
shown in Section 7 B Step 14?

Is any excess wire removed from the Element Feeder? No
wire should be present past the knife as shown in Section 7 B
Step 14.

Open the top cover. Is any excess wire present on the Holder
as shown in Section 7 A Step 18.
5
eWire™
ro
GB