Ewire™ Dies For Advancedpunch Pro; Quick Start Guide - GBC eWire Manual De Instrucciones

5. EWIRE™ DIES FOR ADVANCEDPUNCH PRO
Prior to operation of the eWire™, an eWire™ die set must be
installed into the AdvancedPunch Pro. eWire™ will not function
unless one of the die sets listed below is installed.
Die Set Details
A die set from the following list must be used. Refer to Section 10 of this
document for further details.
Die, eWire, 3:1, Round
Die, eWire, 3:1, Square
Punched Hole Quality
Prior to operating the eWire™ for the first time, or whenever a die set is
changed, perform the hole quality check outlined in Section 9 B

6. QUICK START GUIDE

eWire™ must be connected to AC power and the ON/OFF switch
should be ON to enable any feature of the machine. Below are two
modes of operation:
1. Bypass Mode:
This operation will allow paper to pass through the eWire™.
Step 1: On the LCD user interface screen, press Up or Down key
to enter the Main Menu.
Step 2: Under the Main Menu, select Settings by pressing Enter
key.
Step 3: Under Settings, select Mode to enter the Mode select
menu.
Step 4: Press the Up and Down arrows to toggle between
operation modes. Press Enter when Bypass is highlighted.
Step 5: Exit the menu by pressing Up or Down key and selecting
Exit. Ready Bypass should appear on the display.
eWire™ will now function in Bypass mode.
2. Bind Mode:
This operation will enable eWire™ to bind books.
Step 1: A spool of the correct size twin loop wire must be
installed before running bind mode. See Section 4 for details on
loading twin loop spools into the eWire™
Step 2: On the LCD user interface screen, press Up or Down key
to enter Main Menu.
Step 3: Under the Main Menu, select Settings by pressing the
Enter key.
Step 4: Under settings, select Mode to enter the Mode select
menu.
Step 5: Press the up and down arrows to toggle between
operation modes. Press Enter when Bind is highlighted.
Step 6: Exit the menu by pressing Up or Down key and selecting
Exit. Ready To Bind should appear on the display.
eWire™ will now function in Bind mode.
7714030
7714031
eWire™ must be connected to AC power and the rear ON/OFF
switch should be ON to enable any feature of the machine.
 A spool of the correct size twin loop wire must be installed before
running a bind job. See Section 7 B for details on loading twin
loop spools into the eWire™
 Ensure that the book drawer in Area 4 is set to the size paper
you intend to use, shown below.
 Check that the AdvancedPunch Pro has an eWire™ die as
detailed in Section 5.
DOWN
Layout of eWire™ LCD User Interface
.
6
eWire™
ro
GB
UP
ENTER/
OK