Plc Settings; Find A Parameter And Set Its Value - Nederman FlexPAK 800 DX Manual De Usuario

EN
7 PLC settings
The following PLC displays show the different parameter settings that can be configured for the unit.
7.1 Find a parameter and set its value
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
Set Parameter Set Parameter
Program Name
Do the following to find a parameter and set its value:
1 From the PLC status screen, press the down arrow to go to the date and time screen.
2 Press 'Escape' to go to the main menu.
3 Press the down arrow to go to 'Program'. Press 'OK' to confirm.
4 Select 'Set Parameter'. Press 'OK' to confirm.
5 Use the up or down arrows to find the parameter. Press 'OK' to confirm.
6 Use the left and right arrows to select a value.
7 Use the up or down arrows to set the value. Press 'OK' to confirm.
8 Press 'Escape' to go to the main menu.
9 Press 'Escape to go to the date and time screen.
10 Press the up arrow to exit.
There are several other input menus on the same level as the date and time screen. If pressing the
down arrow takes the PLC to one of those menus, use the left arrow to get to the date and time
screen.
The blinking cursor shows the current value that can be changed.
32
FlexPAK 800/1000 DX
Thu 10:45
2018-02-01
ESC OK
H-Meter
SSR_Time
Cool_Tmr
ClenCyl
FItClean
DIRTime
ESC OK
Stop
Program Program
Setup
Network
Diagnos cs
ESC OK
> H-Meter
> MI
> OT
> MN
> MN Ext
Z
ESC OK
>
> >
>
>
>
ESC OK
1/1
=2000h:0m
=0h:15m
=1999h:45
=2000
ESC OK