Dismantling And Disposal; Problems, Causes And Solutions - Karomat 595 H Manual De Instrucciones

Follow the instructions in the table below for special maintenance.
INTERVAL FOR
MAINTENANCE
Every 100 hours
Every 200 hours
WARNING
• The data in the table are indications.

8 Dismantling And Disposal

Only trained personnel are allowed to dismantle the high pressure cleaner in
accordance with the current regulations in the country where it is installed.
CAUTION
• Before disposing of the high pressure cleaner, make sure it is no longer
possible to operate it, by cutting the power supply cable for example. Make
sure all its parts are inoffensive, as they could prove to dangerous to children
playing.

9 PROBLEMS, CAUSES AND SOLUTIONS

CAUTION
• Before undertaking any action, follow the instructions in the «Switching off»
section. If it is not possible to restore correct operation of the high pressure
cleaner using the information in the table below, contact a Skilled
Technician.
FAILURES
By setting the switch (1) to «1»,
the water cleaner does not
start.
Remember also what
mentioned in the note of
section «Interrupting the use
(Total Stop)».
The water cleaner vibrates a lot
and is noisy.
ACTION
Check the pump hydraulic circuit.
Check the pump fixing.
Replace the pump oil.
Check the pump suction/delivery valves.
Check the pump screws are tightened.
Check the pump adjustment valve.
Check the safety devices.
CAUSES
A safety device of the system
to which the water cleaner is
connected (fuse, differential
switch, etc.) has triggered.
The plug of the power supply
cable is not inserted correctly.
The water inlet filter (15) is
dirty.
The water supply is not
enough.
34
SOLUTIONS
Reset the protection device.
In case of a new triggering,
do not use the water cleaner
and apply to a Skilled
Technician.
Disconnect the plug from the
socket and reconnect it
correctly.
Observe what mentioned in
the section «Routine
maintenance».
Check that the tap is
completely opened and that