Operation - Karomat 595 H Manual De Instrucciones

• Do not operate the high pressure cleaner with a priming depth in excess of 0
m / 0 ft.
• Do not operate the high pressure cleaner if it is not connected to a water
supply.
• Do not supply the high pressure cleaner with salt water or water containing
impurities. In this event, run the high pressure cleaner for a few minutes with
clean water.
CAUTION
• Follow current regulations for connection to the mains water supply in the
country where the water cleaner is installed.
4.3 Checks and Connection to the Mains Electricity Supply
CAUTION
• A Skilled Technician must check that the electrical supply complies with the
data indicated on the identification label (18) on the high pressure cleaner. It
is especially important that the supply voltage does not differ more than +-5%
from that indicated on the label.
• All connections to mains electricity must be carried out by a Qualified
Eletrician according to IEC 364 regulations or the equivalent standard in the
country where the high pressure cleaner is to be used. It is especially important
that the current outlet where the high pressure cleaner is connected is provided
with an earth conductor and a suitable fuse (according to the size indicated on
the identification label and in the table of technical specifications), and must be
protected by a magneto-thermal differential circuit breaker, whose sensitivity is
not in excess of 30 mA.
• If the power supply cable is too short, an extension cord can be used
provided it is not longer than 10 m / 32.8 ft, the section of the wires is at least
1.5mm and the plug and the socket are waterproof. Contact a Qualified
Eletrician so that all these requirements are followed.
The use of unsuitable extension cords can be dangerous.

5 Operation

CAUTION
• The high pressure cleaner must be used with care and attention. It is your
responsibility to make sure that any infrequent users have read these
instructions and are acquainted with the operation of the water cleaner;
otherwise do not allow others to use the high pressure cleaner. Water
cleaners must not be used by children or by unauthorised personnel.
• Comply with the safety warnings in the operating and maintenance
instructions of any optional accessories to be used.
• Do not use the high pressure cleaner if:
- the power supply cable or other important parts such as the high pressure
pipe, the safety devices, the cleaner gun and the lance are damaged;
- the high pressure cleaner has been tipped over or has been bumped;
- there are obvious leaks of water.
28