Cleaning And Maintenance; Routine Maintenance; Special Maintenance - Karomat 595 H Manual De Instrucciones

7 C
LEANING AND
CAUTION
• Only start cleaning and maintenance once the instructions in the «Switching
off» section have been completed.
It is particularly important to always disconnect the electricity supply.
• To safeguard the safety of the high pressure cleaner, only use the original
spare parts supplied by the Manufacturer or those endorsed by him.
• The rubber pipes, the coupling and the high-pressure lances are important for
safety: only use those endorsed by the Manufacturer.

7.1 Routine Maintenance

Follow the instructions in the «Switching off» section and abide by the
recommendations in the table below.
INTERVAL FOR
MAINTENANCE
Each time used
Weekly
Monthly
WARNING
• During use, the high pressure cleaner should not be too noisy and large
amounts of water or oil should not drip from underneath it.
In this event, a Skilled Technician should test the appliance.

7.2 Special Maintenance

CAUTION
• Only Skilled Technicians are authorised to carry out special maintenance.
M
AINTENANCE
ACTION
• Check the supply cable, high-pressure pipe, couplings,
cleaner gun, lance pipe.
Should any of these parts appear to be damaged, do not
use the high pressure cleaner and contact a Skilled
Technician.
• Clean the water inlet filter (15).
Usually, it is sufficient to pass the filter under running water or
in a jet of compressed air to clean it. In more difficult cases,
use a lime scale remover or replace the filter. Contact an
authorised service centre for the purchase of a new filter.
• Clean the nozzle.
For cleaning, it is generally enough to pass the supplied pin
(17) inside the nozzle hole. In case you do not obtain any
appreciable result, replace the nozzle by using the supplied
wrench 16. For purchasing the spare part, apply to an
authorised service centre.
33