Optional Accessories; Installation; Assembling The Accessories - Karomat 595 H Manual De Instrucciones

3.3 Optional Accessories

The standard accessories for the high pressure cleaner can be integrated with
the following vast range of accessories:
• Sandblasting lance: designed for smoothing down surfaces, eliminating rust,
paint, deposits etc.
• Pipe-draining probe: designed for unblocking pipes and ducts.
• Underbody lance: designed to reach the most difficult areas of access.
• Rotating water jet brush: designed for cleaning delicate surfaces.
• Rotojet: designed to eliminate the toughest dirt.
• Foaming lance: designed for the most efficient distribution of detergent.
CAUTION
• The operation of the water cleaner may be impaired if unsuitable accessories
are used and they may even make it dangerous. Only use original
accessories endorsed by the Manufacturer.
Refer to the documents provided with the optional accessories for information
regarding their general use, safety warnings, installation and maintenance.

4 Installation

See Fig. A at the front of these operating and maintenance instructions.

4.1 Assembling the Accessories

a) Insert the lance hose (11) on the water gun (8) and tighten.
b) Mount the accessory support (26) on the handlebar (30); mount the knob and
the lever (13) on the hose reel (6).
c) Mount the hose (25) between the hose reel and the water cleaner, by
tightening the two fast coupling connectors; release the locking device (24) of
the hose reel (6); unroll the hose quantity (7) that is necessary by rotating the
hose reel by means of the knob (13), then lock the device (24).
d) Unroll the high-pressure hose (7) and connect the fast coupling connector to
the water outlet connector (5).
e) Screw the end of the high-pressure pipe (7) on the water gun thread (8) and
tighten with two 17-mm box wrenches (not supplied).
f) Insert the water suction filter (15) into the water suction connector (14) and
tighten it on the water inlet connector of the water cleaner.
4.2 Controls and Connection to the Mains Water Supply
WARNING
• The water supply must be able to guarantee the adequate delivery of water
flow to the high pressure cleaner; refer to the table of technical specifications.
In case of doubt, contact a Skilled Technician.
• Do not supply the water cleaner with water at a temperature in excess of
50°C/122°F or below 5°C/41°F.
• The pressure of the water supply must not be in excess of 8 bar/116 psi.
27