Preliminary Procedures; Standard Operation - Karomat 595 H Manual De Instrucciones

- after use;
In addition, wait until the high pressure cleaner has completely cooled down
before cleaning or maintenance.
• During use, do not lock the lever (9) on the cleaner gun in the open position.
• Do not remove the plug from the power outlet by pulling on the power supply
cable.
• Do not put any reducers or adaptors between the electric plug and the power
outlet.
• Keep the power supply cable, any extension cords, the plugs and the outlets
dry. Do not touch them with wet hands.
• If the supply cord is damaged, it must be replaced by the Manufacturer or by
a Skilled Technician, in order to avoid a hazard.
• Do not cover the high pressure cleaner during operation and do not place it
where there is inadequate ventilation.
• When the high pressure cleaner is used in enclosed spaces, make sure that
there is adequate ventilation.

5.1 Preliminary Procedures

• Unroll the high-pressure pipe (7) completely.
• Attach a supply pipe to the water inlet's quick connection (14) using a normal
garden connector.
• Open the tap to the water supply and make sure that there are no drips.
• Make sure that the main switch (1) is in the off position (the «0» position) and
put the plug into the electric current outlet.
• Turn the main switch (1) to position «1».
• Press the cleaner gun's control lever (9) and wait for a continuous jet of water
to be issued.
• Turn the main switch (1) to position «0» and connect the lance pipe (11)) to the
cleaner gun (8).
5.2 Standard Operation (high pressure)
• Make sure that the nozzle head (12) is not in the position for supplying
detergent (also see the «Use with detergents» section).
• Restart the high pressure cleaner by turning the main switch (1) to position «1»
and check that the spray from the nozzle is uniform, without dripping.
Note: during this restart phase, the high pressure cleaner will immediately stop
operating after the initial peak, as the Total Stop device will take effect.
• Use the cleaner gun's lever (9) to start operation of the high pressure cleaner
and thus start cleaning.
• The pressure value can be read on the pressure indicator (3).
30