Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2.1 Identification of Components
Please also refer to figures 1 to 4, which are located at the start of these
operating and maintenance instructions.
1. Switch
2. Electrical wire + plug
3. Pressure indicator
4. -
5. -
6. Hose reel
7. High-pressure hose
8. Water gun
9. Water gun lever
10.
Water gun lever safety lock
11.
Lance hose
12.
Nozzle-holding multi-adjusting
head
13.
Knob and hose reel lever
14.
Water suction connection
15.
Water suction filter
2.2 Safety Devices
This water cleaner is provided with the following safety devices:
a)
Amperometric protector
This blocks the operation of the water cleaner in case of excessive
consumption of electrical current.
In this case, proceed as follows:
- switch the main switch (1) to position «0» and remove the plug from the
power outlet;
- press the lever (9) on the cleaner gun to eliminate any remaining pressure;
- wait 10 to 15 minutes until the water cleaner cools down;
- check that the instructions in the «CHECKS AND CONNECTION TO THE
MAINS ELECTRICITY SUPPLY» section have been followed, particularly
regarding any extension cord used;
- replace the electric plug in the power outlet and repeat the start-up procedure
described in the «OPERATION» section.
CAUTION
•
If this safety device cuts in repeatedly, do not use the water cleaner until it
has been checked by a Skilled Technician.
b)
Pressure limit/adjustment valve
16.
Setscrew
disassembly
17.
Pin for nozzle cleaning
18.
Technical data plate
19.
Room for housing the lance pipe
20.
Room for housing the water gun
21.
Support to wind the electrical wire
22.
Rotojet
23.
Guaranteed sound power plate
24.
Hose reel locking
25.
Water cleaner/hose reel connecting
hose
26.
Accessory support
27.
Caution plate
28.
Thermal switch
29.
Warning plate
30.
Handlebar
31.
Foaming lance
24
wrench
for
nozzle
Capítulos
Tabla de contenido
