Suzuki 990D0-22H00-ALM Manual De Instalación página 3

Idiomas disponibles
  • ES

Idiomas disponibles

j)
Place the control unit as indicated in picture 3. The fixing bracket holes must correspond to the control unit
fixing slots (picture 3
k)
Secure the alarm unit by 2 tie raps "5" (picture 3
l)
Route the plug&play harness under the frame (picture 3
(picture 4
m)
Secure the harness by one tie rap "5" at the mounting bracket (picture 3
n)
Remove the original OE-jumper of the 4-pin alarm connector and connect the plug&play harness counterpart.
o)
Connect the 1-pin connector (picture 4
p)
Identify and disconnect the 6-pin turn indicators connector (picture 4
harness counterparts.
q)
Place the fuse housing (picture 5).
r)
Clean the protection foil mounting area at the left lower frame cover with a suitable cleaner (picture 6).
s)
Clean the LED mounting area at the right lower frame cover with a suitable cleaner (picture 6).
t)
Glue the protection foil "8" on the left and the LED "2" on the right lower frame cover (picture 6).
u)
Remount the right lower frame cover and route the LED cable to the 2-pin connector of the plug&play
harness. Connect the LED with the plug&play harness and secure the LED cable with a tie rap "5".
v)
Reconnect the negative battery pole remount the left lower frame cover and the seat. Tighten the three seat
bolts with a tightening torque of 23 Nm.
3.
System check
a)
To arm the system push once BUTTON 1 of the remote control.
Arming is confirmed by:
2 turn indicators alternated flashing (right-left-right-left)
2 acoustic signals (bleep)
LED turns on (quick flash)
The system is operating after 40 sec. «Standby Time»: the motorbike cannot be started
b)
Move the motorbike to test that the movement sensor is operating
flashing during 30 sec.
c)
At the end of the alarm phase the LED is steady ON.
d)
To disarm the system push BUTTON 1 of the remote control.
Disarming is confirmed by:
1 turn indicators alternated flashing (right-left)
1 acoustic signal
LED gives 1 flash every 5 sec. to confirm an alarm due to a position variation
impulse (ON-OFF) on the ignition key.
e)
To activate the PANIC alarm push once BUTTON 2 of the remote control
indicators are flashing during 30 sec. (to stop this test push or BUTTON 1 or BUTTON 2).
f)
Re-assemble the parts previously removed.
g)
End of installation.
4.
What to be done before delivering the motorbike to its owner
a)
Deliver to the owner the two remotes control together with the metal plate where the releasing emergency
"PIN CODE" is printed and the during installation removed OE-jumper.
b)
Explain to the owner the releasing emergency procedure
C,
D). Press for a few seconds.
A).
SUZUKI GENUINE ACCESSORIES
C,
D).
E) to the 4-pin connector of the motorbike harness
B) (+12V) to the plug&play harness counterpart.
F).
C) and interpose the plug&play
Led flashes slowly
siren sounds and turn indicators are
to reset the alarm memory give an
the siren sounds and turn
3
loading