Nice Era Mat T Instrucciones Y Advertencias Para La Instalación Y El Uso página 12

04
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.16 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
5.16.1 - Procedure performed with a transmitter memorised in "Mode I"
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory: Keep the s and t keys pressed and wait for the motor to perform five movements. Upon completion, release the keys.
• To delete only the memorised transmitters: do not press any key and wait until the motor performs five movements.
• To delete only the limit switch heights ("0", "1", "2", "S") and intermediate heights ("H"): WARNING: – This deletion must be performed only when
you want to adjust the limit switch heights again, using a different procedure than the one used previously. Keep the n key pressed and wait for the
motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
04
3
5
sec.
Note – When performing the procedure, at any
time you can cancel it by keeping the n and t
keys pressed simultaneously for 4 seconds. Other-
wise, do not press any key and wait 60 seconds
for the motor to perform 6 movements.
5.16.2 - Procedure performed with an unmemorised transmitter
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Disconnect power supply from motor.
02. Connect the White and White-black wires to each other.
03. Disconnect power supply from motor.
04. Lastly, perform the procedure indicated in paragraph 5.16.1.
01
OFF
11 – English
( )
"1"
"1"
"S"
02
2
02
white
white-black
05
"S"
fine regulation
3
5
sec.
05
all
data
5
sec.
05
only
5
sec.
05
"0"
"1"
5
"H"
sec.
03 04
ON
3
5
sec.
03
5
3
sec.
5
END
5
END
5
01 02 03 04
Paragraph 5.16.1
END
END
05
END