Desoutter SLK017L Manual De Instrucciones página 10

6159934990
Issue no : 01
© COPYRIGHT 2008, DESOUTTER
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
Product is designed for installing and removing
threaded fasteners in wood, metal and plastic.
No other use permitted.
For professional use only.
DATA
(See page 4).
Noise level: < 70 dB(A) (EN 60 745).
Vibration level: < 2.5 m/s² (EN 60 745).
Declaration of noise and vibration emission
These declared values were obtained by
laboratory type testing in compliance with the
stated standards and are not adequate for
use in risk assessments. Values measured in
individual work places may be higher than the
declared values. The actual exposure values
and risk of harm experienced by an individual
user are unique and depend upon the way the
user works, the work piece and the workstation
design, as well as upon the exposure time and
the physical condition of the user. We, Desoutter,
cannot be held liable for the consequences of
using the declared values, instead of values
re ecting the actual exposure, in an individual
risk assessment in a work place situation over
which we have no control.
REQUIREMENTS
These tools need to be use with controllers
ESP1 / ESP2.
ELECTRICAL CONNECTION
(See page 5).
ACCESSORIES
A wide range of accessories are available and
suitable items should be selected from the
relevant Desoutter Catalogue.
10 / 44
OPERATING INSTRUCTIONS
A B
0.8s >3.2s
To remove a previously tightened xing,
reposition the switch in position unscrewing
(Fig.B) and increase the torque setting (Fig. C).
Again press the tool into the xing and it will
unscrew.
MAINTENANCE INSTRUCTIONS
Regular inspection of the mains cable (1)
must be carried out and if damaged it must be
replaced.
WARNING
Part No.
6153603350
6153603360
6153603370
PC-TPR
6153603380
When disposing of components,
lubricants, etc ... ensure that the
relevant safety procedures are carried
out.
ASSEMBLY AND DISMANTLING
Failure to have repairs carried out by a suitably
quali ed electrician can result in danger to the
user.
When dismantly and assembling, follow normal
engineering practices. Unsolder only those wires
necessary for component removal. Always note
colour code and location of wires for correct
assembly. Refer to the illustration and build
components into sub-assemblies. On assembly
ensure earth strap is properly secured to
gearbox/clutch assembly.
C
Nm
=
01/2009