Replacing Fuel Filter - RIDGID RD9H7001P Manual Del Operador

MAINTENANCE

REPLACING FUEL FILTER

See Figure 20.
Occasionally the fuel filter may become clogged and need
to be replaced. To purchase a replacement fuel filter contact
customer service or a qualified service center.
NOTE: Fuel tank must be empty before replacing fuel filter.
Run unit until tank is empty, if needed, or inspect filter prior
to fill-up.
STORAGE
When preparing the generator for storage, allow the unit to cool for 30 minutes then follow the guidelines below.
STORAGE
TIME
Less than 2  Drain gasoline from tank and dispose of in a suitable container according to state and local ordinances.
months
2 months to 1  Drain fuel from carburetor.
year
 Drain gasoline from tank and dispose of in a suitable container according to state and local ordinances.
1 year or more  Drain fuel from the carburetor.
 Remove spark plug.
 Drain gasoline from tank and dispose of in a suitable container according to state and local ordinances.
 Put a tablespoon of engine lubricant into the spark plug cylinder. Turn the engine slowly with the pull
rope to distribute the lubricant.
 Reinstall spark plug.
 Change engine lubricant.
After removal from storage:
 Fill with fresh gasoline.
NOTE: If storing gasoline in suitable container for later use, make sure gasoline has been treated with fuel stabilizer
according to stabilizer manufacturer's instructions.
To replace:
 Turn the fuel valve to the OFF position.
 Remove the fuel lines from both sides of the filter by
squeezing the ends of the retaining clips with pliers.
 Slide the fuel lines off.
 Replace with new fuel filter.
 Reinstall fuel lines and retaining clips to new fuel filter.
 Turn the fuel valve to the ON position.
PRIOR TO STORING
19 — English