RIDGID RD9H7001P Manual Del Operador página 17

ASSEMBLY
INSTALLING THE FRAME SUPPORT
See Figure 5.
Install the frame support on the bottom of the generator
frame on the same side as the handle.
 Locate the following items:
Frame support with feet
2 washers (M6)
2 bolts (M6 x 25 mm)
 Raise the end of the generator where the recoil starter is
located high enough to gain access to the frame bottom;
securely position props underneath to support.
 Align the holes on the frame support with the holes on
the generator frame.
 Slide a washer on the bolt, then insert the bolt through
the hole in the generator frame and through the frame
support.
 Thread bolt into hole in frame support with foot and
tighten securely.
 Repeat on other side.
INSTALLING THE WHEELS
See Figure 6.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the side
opposite the handle.
 Locate the following items:
2 axles
2 hitch pins
2 washers
2 wheels
 Raise the end of the generator opposite where the handle
is located high enough to gain access to the frame
bottom; securely position props underneath to support.
 Slide the axle through the hole in the center of the wheel.
 Slide a washer onto the axle, then slide the axle into the
wheel mounting hole as shown.
 Insert hitch pin to secure.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
LOCKING THE HANDLE
See Figures 7 - 8.
 Locate the following items:
2 handle lock pins
2 lanyards
 Attach the lanyard to the handle lock pin and the handle
as shown in figure 7.
 Extend the handle, then insert the pin through the hole
in the handle and the generator frame to secure handle
in place.
 Repeat the process on the other side to lock the other
handle.
CAUTION:
Do not attempt to lift the unit by the handle
assembly. If it is necessary to lift the generator,
always grasp by the frame. Use proper lifting
techniques to avoid back injury.
RELEASING THE HANDLES
 Remove the handle lock pins and lower the handles to
the down position.
13 — English