Power Supply; Getting Started - Roadstar CLR-2619 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23

POWER SUPPLY

This unit operates from a main supply of 230V ~ 50Hz. Connect the AC power cord to the AC
household main outlet. Ensure that the voltage is as indicated on the rating plate on the rear
of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time and alarm settings in
the event of a temporary power interruption.
Install 1 x 3-volt CR2032 Flat Lithium battery, not included, into the battery compartment
located on the bottom of the unit, making certain that the positive and negative (+ and -) battery
terminals are attached to the corresponding terminals on the plate in the battery compartment.
If power is temporarily interrupted the display will blink and the radio will not play. However,
the battery back-up circuit will continue to maintain the clock and alarm settings. When power
is restored the clock will display the correct time and alarm settings, and no adjustment is
necessary.

GETTING STARTED

Press the Reset button (17) located on the back of the unit after pluging in the AC cord.
-
The unit will display full segment for 2 seconds, then it will enter the normal mode.
-
The Display will light up.
1. TIME AND CALENDAR SETTING
A. Setting Time and Calendar - Press Mode Set button (1) in normal mode and keep pressed
over 2 seconds to enter Time Set mode. After entering the setting mode, press Mode Set
button (1) to change the mode cycle as follows :
Normal > Year > Month > Day > 12/24H > RTC Hour > RTC Min > Normal
Action (during data adjustment) :
-
Press >> button (7) to adjust data forward
-
Press << button (8) to adjust data backward
-
Keep pressed << or >> button for 2 seconds to enable auto forward or backward
3
English
a. Year Set Mode
b. Month Set Mode
c. Day Set Mode
Remark : Weekday will recalculate when year, month or day is adjusted
d. 12/24H Set Mode
e. RTC Hour Set Mode
f. RTC Min Set Mode
Remark : Second will reset for every minute adjustment
4
English
Initial Value : 2009
Year Range
: 2000 to 2099
Display showing Year Set Mode
M
D
Display showing Month Set Mode
M
D
Display showing Day Set Mode
Display showing 12/24H Set Mode (Select 12H)
Display showing 12/24H Set Mode (Select 24H)
Display showing Hour Set Mode
Display showing Min Set Mode
Tabla de contenido
loading

Tabla de contenido