Thermor Flat 30 Manual De Instrucciones página 7

11. Operate regularly the discharge of safety device to prevent scaling and
check that it is not blocked.
12. Hydraulic accessories should not be located between the safety valve
and the cold water inlet. A pressure reducer (not supplied) is required when
the water supply pressure exceeds 5 bar (0,5 MPa) and will be fitted on the
main supply.
13. Connect the safety device to an unpressurised outlet pipe in a frost free
location, with a continuous slope to evacuate water during heating up or
draining the water heater.
14. The pipes used must support 10 bars (1 MPa) and 100 ° C.
15. To drain the device: Switch off the power and the supply of cold water,
open the hot water faucets and manipulate the safety valve. To drain under
sink water heater disconnect the hydraulic connections and return the device.
16. The products described in this manual are subject to changes at any time
to be in accordance with technology and standards. The devices comply with
Electromagnetic Directive 2014/30/UE, Low Voltage Directive 2014/35/UE,
Directive 2011/65/UE for RoHS and Regulation 2013/814/UE supplementing
Directive 2009/125/EC for ecodesign.
17. Do not dispose your water heater in the garbage, but hand it to a
place assigned for this purpose (collection point) where it can be
recycled.
18. This product is intended for use at a maximum altitude of 2000m.
7