Idiomas disponibles
Idiomas disponibles
CLEANING AFTER USE
CAUTION
!
IMPORTANT
„ After the steam cleaner is used, press the Power Button to turn power "OFF"
and then unplug the Power Cord from wall outlet.
„ Press down the Steam Trigger to release all pressure.
„ Wait 7-10 minutes until the Safety Pressure Indicator has gone down,
which indicates the steam cleaner has cooled. After 10 minutes, if the Safety
Pressure Indicator has not fully dropped, release residual pressure by pressing
Steam Trigger. Slowly start to unscrew the Water Fill Safety Cap counter-
clockwise while gently pushing on the Safety Pressure Indicator. DO NOT
FULLY UNSCREW THE WATER FILL SAFETY CAP. Allow steam cleaner to
cool an additional 5 minutes. After you have ensured the steam cleaner has
cooled and pressure has been released, the Water Fill Safety Cap should turn
freely for removal. Unscrew the cap completely (3.8).
„ Empty the residual water in the tank and allow to dry. Clean the external
surface with a dry cloth. Re-install the Water Fill Safety Cap in a clockwise
direction and tighten until completely sealed.
„ DO NOT OVERTIGHTEN SAFETY CAP.
CAUTION
!
ATTACHING ACCESSORIES
See the "Accessories Chart" on page 9 for suggested use and extensions required.
STEAM NOZZLE
„ The Steam Nozzle is permanently attached to Handheld Steam Cleaner
and can be used for direct steam application or to attach desired accessories.
See "Accessory Chart" on page 9 for which accessories can be attached.
TURBO NOZZLE EXTENSION
How to Attach and Remove
„ Fit the Turbo Nozzle Extension over the Steam Nozzle on Handheld
Steam Cleaner (4.1). Align the orientation marks and rotate clockwise until
Turbo Nozzle Extension is in locked position and secure. Once Turbo
Nozzle Extension is attached, use for direct steam application or attach
desired accessories. See "Accessory Chart" on page 9 for which accessories
can be attached.
„ To remove Turbo Nozzle Extension rotate counter-clockwise and gently pull
away from steam cleaner.
HOSE
How to Attach and Remove
„ Fit the Hose Assembly with built in handle over the Steam Nozzle on Handheld
Steam Cleaner (4.2). Align the orientation marks and rotate clockwise until
hose assembly is in locked position and secure.
„ To remove assembly, slide release button at the base of Hose away from
steam cleaner and rotate counter-clockwise and pull away Hose.
Attaching Accessories to Hose Assembly with Built-In Handle
„ Once Hose Assembly is attached, you can attach the wand or wedge
accessories to the Hose Handle (4.3, A) (See "Accessory Chart" on page 9).
To connect the wand and wedge, pull back the quick release ring (4.3, B) on
handle and insert the wand or wedge. Once wand or wedge is attached,
release the ring (4.3, B), attach the corresponding Microfiber Pad over frame
and secure with the bungee clip. See "Accessory Chart" on page 9 for
suggested use. See "Maintenance" section on page 10 for cleaning instructions.
To avoid burn injury, do not refill Water Tank before steam cleaner has cooled
completely. Use caution when removing Water Fill Safety Cap. Even when
cap is able to be turned the steam cleaner may still be hot, especially all
metal surfaces.
Make sure safety cap is tightened securely before continuing use or for storage.
4. HOW TO USE: ACCESSORIES
Turn off, unplug, and allow steam cleaner to cool before removing
accessories. Always have the nozzle pointed away from you and others
during installation.
8
3.8
A
4.1
4.2
4.3
A
B
Capítulos
