Olympia PS 706.3 CCD Manual De Instrucciones página 22

8 Clearing Material Jams
If too much material (paper, CDs, credit cards) is fed to the cutting mechanism at one
time, the material jams. The shredder switches off automatically in the event of a material
jam.
Proceed as follows:
Press the REV button to activate reverse operation and feed the material back out.
●
Activate the FWD function to clear the infeeds of any residual material.
●
If necessary, remove any residual material manually from the automatic paper infeed.
●
Press the AUTO button to reactivate the automatic function.
●
Reduce the quantity of material being fed into the shredder.
●
8.1 REV button (reverse operation)
Press the REV button so that the cutting mechanism runs in reverse and feeds the
material back out of the shredder indeed.
Note: If a material jam has occurred when the automatic paper infeed is in opera-
tion, you must also check whether there is any residual paper in the infeed
and remove it as well!
8.2 FWD button (forward operation)
Press the FWD button to run the cutting mechanism forwards and shred any residual
material left in the infeed and feed it out of the cutting mechanism.
Note: The FWD button is used after clearing a material jam to start the cutting
mechanism running without feeding any new material through the respec-
tive infeed.
8.3 Removing residual paper from the automatic paper
infeed.
1. Set the On/Off switch to its OFF position and disconnect the power plug from the
power socket.
2. Unlock the automatic paper infeed by turning the locking bolt to its OPEN position
using a coin.
3. Hinge up the safety guard on the automatic paper infeed.
4. Remove any jammed paper carefully from the cutting mechanism using a suitable
tool.
5. Hinge the safety guard on the automatic paper infeed back down.
6. Lock the safety guard of the automatic paper infeed by turning the locking bolt to its
LOCK position using a coin.
7. Reconnect the power plug in the power socket and set the On/Off switch to ON.
22