Idiomas disponibles
Idiomas disponibles
· This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. Due
to blocked air vents). For safety reasons, the fire will NOT automatically reset.
· To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect the supply to the mains and switch on the appliance.
Replacing the Lamp
· Warning：Always disconnect from the power supply before removing bulb.
· Warning：The bulbs reach high temperatures during operation. Allow the bulbs to cool down
after switching off the appliance before changing lamps.
· At the back and bottom of fire, there is a lamp cover fixed by two head screws, remove the two
screws and lift off the lamp cover.
· For access to the bottom bulbs, carefully slide the flexible rotisserie to one side ensuring that
the rubber grommet is not lost.
· Remove the defective bulb by pulling it out of the holder.
· Replace with a same 40W bulb. Take care not to touch the bulb with bare hands and ensure
that the bulb is pushed home.
· Refit the rotisserie making sure that the rubber grommet is carefully pushed into the slotted
hole on the axial bracket.
· Refit the lamp cover.
Cleaning
· Warning-Always disconnect from the power supply before cleaning heater
· For general cleaning use a soft clean duster-never use abrasive cleaners. The glass viewing
screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners
Disposal
· At the end of the product's serviceable life it should be disposed of thoughtfully and safely in
accordance with local authority regulations. The plug should be
Removed from the power supply cord and the power cord cut from the heater
Technical Specification
45
