Samson Synth Seven Manual Del Usuario página 7

Quick Start
Multiple System Setup
Press and hold the power button to turn on the UR7 receiver.
Press the Menu/Select button to enter the Main Menu. Rotate the Menu/Select encoder to highlight GROUP &
CHANNEL and press the MENU/SELECT button to enter the menu.
Set each receiver to the same Group. Select GROUP and press the MENU/SELECT button. The Group letter
will start to flash. Rotate the MENU/SELECT encoder until you have selected the desired group and press the MENU/SELECT button to set the receiver Group.
Select GROUP SCAN and press the MENU/SELECT button. The UR7 receiver will scan the selected Group for
an available channel.
Group & Channel
Group
Channel
Group Scan
IR Set
Back
Set the transmitter:
Install two fresh AA batteries into the UB7 belt pack or UH7
handheld transmitter. Press and hold the power button to turn
on the transmitter.
On the UR7 receiver scroll down to IR SET and press the
MENU/SELECT button.
Position the transmitter about 6-12" (15-30 cm) from the front
of the UR7 receiver with the transmitter's IR window facing
the IR transmitter on the front panel of the receiver. The UH7
transmitter IR window is inside the battery compartment. The IR
windows on the UB7 is next to the LCD display.
When the transmission is complete, select BACK or press
the power button on the UR7 receiver to return to the main
performance display.
Once a transmitter and receiver pair is set, leave the transmitter
powered on and locked before scanning the group for the next available channel. This will prevent the receiver
from selecting a channel that will cause interference.
Set the performance level
Speak or sing into the microphone, or if you are using the transmitter with a connected instrument, play the
instrument at normal performance level. Slowly raise the volume of your amplifier or mixer until the desired level
is reached.
If you find the system has noticeable dropouts, reduced overall working range, or unexpected noise bursts,
change the operating channel of the system using the steps above.
Group & Channel
B
Group
01
Channel
Group Scan
IR Set
Back
Group & Channel
B
Group
Channel
Group Scan
IR Set
Back
B
05
7