Pride TRAVEL SCOOTER Serie Manual De Instrucciones página 12

1
Figure 10. Securement Points (Identifi ed with black dots)
SHROUD PANELS
On certain models, you can change the color of your
Travel Scooter by removing the colored plastic shroud
panel pieces and replacing them with one of the other
supplied sets. The panels are held in place by a hook and
loop reusable fastener. See Travel Scooter Features
Table (inside front cover).
To remove the shroud panel pieces:
1. Use your fi nger to locate the push hole behind each
shroud piece.
2. Push through the hole to separate the piece from the
Travel Scooter. See fi gure 11.
To remove the tiller console visor:
1. Gently pull the top of the visor away from the tiller
console, then slowly lift it up and away from the tiller
console. See fi gure 12.
To reinstall the shroud pieces, place each piece in its
appropriate location and push with slight pressure to
secure the reusable fastener.
NOTE: When installing the front and rear fender
panels, make sure the tab at the bottom of each panel is
inserted into the tab opening before securing the panel.
See fi gure 11.
12
I I . Y O U R T R A V E L S C O O T E R
IDENTIFICATION KEY
1. Front Securement Points (3-wheel models)
1a. Models 83 and 84 only
1b. Models 36, 39, 40X, 44X, 40E, 44E, 40LX, 44LX, 49, 50LX,
54LX, 53, 53HD, 54, 54HD, 73, and 74
2. Front Securement Points (4-wheel models)
3. Rear Securement Points
2
1a
1b
3
IDENTIFICATION KEY
1. Rear Fender Panel
2. Front Fender Panel
1
2
1
Figure 11. Fender Panels
Figure 12. Tiller Console Visor
2
2
1
2
1
Travel Scooter Series