Seko PROMAX Manual De Instrucciones página 4

ProMax – Proportioning System
TECHNICAL FEATURES :
Water supply connection Possible from right or left
Type of connection
Type of disconnection
Venturi flow rates
Actuating systems
No. of product inlets
Maximum dimensions
Working pressure
Temperature
Notes
READ CAREFULLY BEFORE INSTALLING:
I
The correct procedures for dispenser installations are provided.
I
DO NOT INSTALL where the dispenser is directly exposed to vapours or chemical fumes.
Do not position near sources of heat.
I
PROTECT YOURSELF - wear protective clothing and eyewear when installing or
maintaining the system, take specific precautions as necessary
I
FOLLOW THE SAFETY AND HANDLING INSTRUCTION of the chemical manufacturer.
I
DIRECT THE DISCHARGE HOSE ONLY INTO A SPECIFIC CONTAINER, not toward yourself
or another person
I
CALIBRATE THE DOSING as per the manufacturer's instruction
I
This unit is supplied with an internal backflow prevention device to avoid water supply
contamination. Local compliance standards may vary. Some jurisdictions may require a backflow
prevention device at the system's water inlet.
I
MAXIMUM WORKING PRESSURE is 9bar and is intended as a static pressure reached
progressively. Water hammer pressures exceeding 9bar, resulting from the sudden opening
of a water source or other causes within the facility, may damage the system. Use of an in line
pressure reducer is advisable where these conditions are present. The water supply should
be turned off when the system is not in use.
!
TO PREVENT SIPHONING and to comply with ASME A112.1.2, install the dispenser so the end
of the discharge tube is a minimum 4" above the flood level of the sink or other fixed
container.
!
THE DISPENSER SHOULD BE INSTALLED approximately 5 ft (1,5 m) from the ground and near
the chemical containers for convenient use
ProMax
¾" Female GHT
F-Gap (Flexible membrane)
A-Gap (Physical, Visible Gap)
1GPM (4lt/m)
(Gray)
Button
1 (models B1 and S1)
H = 8 ¾''
(22 cm)
Min 15 PSI (1bar)
Ideal: 30 - 60 PSI (2 – 4bar)
Max 160 °F (70°C)
Possibility of adding modules after installation
Cod. 0000137667
4GPM (16lt/m)
(Yellow)
Slide-up (one hand fill)
4 (models B4 and S4)
W = 3 7/8" D = 4 ¾"
(10 cm)
Max 130 PSI (9bar)
rev. 1.5 EN
8GPM (30lt/m)
(Blue)
(12 cm)
2