babymoov A002051 Instrucciones De Uso página 12

In order to sterilize perfectly, the following points are essential:
- Always wash your hands before preparing a bottle.
- Complete sanitization is only guaranteed when the process has not been interrupted.
- Use tap water with no added product.
- Before any sterilization process, it is important to wash all the bottles and accessories, rinse them with cold water then empty them.
- Even the slightest trace of milk provides a breeding ground for bacteria.
At home
1. Open the lid (b) thanks to its handle (a).
2. Take out the measuring cup (d).
3. Remove the stand (c).
4. Remove the grille (f) from the bottle warmer.
5. Pour 30 ml of water into the basin, using the measuring spoon (½ 1 measuring spoon) or a feeding bottle.
6. Put the grille (f) back on the tank.
7. Hold the grille's handle (g) to OPEN the grill by turning it clockwise. This will ensure that the steam comes out from the bottom of the
appliance, directly inside the bottle.
8. Place the bottle upside-down on the grille (f). Arrange the accessories around the bottle.
9. Close the lid (b) and lock it by turning it anti-clockwise.
10. Plug the appliance into mains. Press the "On" button (e) o start the cycle. The lamp will illuminate to show that the appliance is
working. It will go out automatically and an audible alarm will tell you that the cycle is complete.
11. Hold the lid's handle (a) and turn it clockwise to unlock the lid.
12. Remove the bottle carefully; it will be hot.
13. For optimum sterilisation, we would advise carrying out a second sterilisation cycle.
In car
- Stop the car / vehicle and keep the engine running.
- Place the Bottle Warmer on a flat and stable surface inside your car and vehicle.
- Repeat steps 1 – 13 as above, replacing step 10 by the following instructions :
10. Connect the Car Adaptor Plug (h) on to the power cord of the bottle warmer. Plug the Car Adaptor Plug into the cigarette socket.
Press the "On" button (e) to start the cycle. The lamp will illuminate to show that the appliance is working. It will go out automatically
and an audible alarm will tell you that the cycle is complete.
Cleaning
- Never submerge the appliance in water, and don't fill it right up with water.
- Use a slightly damp cloth to clean the inside and outside. Never use any kind of detergent to clean the inside and outside.
- The measuring cup and stand can be washed in the dishwasher.
De-scaling
Do not use any de-scaling products.
Depending on how hard the water used is and after a certain period of time, a layer of scale may build up in the tank. In order for the
appliance to work properly, the tank needs to be de-scaled regularly.
Proceed as follows: mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank. Leave to act for 30 minutes then empty
the appliance. Then use a damp cloth to clean it.
The bottle warmer doesn't heat up:
- check the "On" button to make sure it is properly switched on,
- check that the appliance is properly plugged in,
- check that there is not too much scale in the tank, and de-scale if necessary.
The warming cycles are too short or too long:
There is not enough or too much water: adapt the amount of water in the tank.
12
MAINTENANCE
IN CASE OF ANY LITTLE PROBLEM
CAR/HOME TURBO STEAM BOTTLE WARMER • Instuctions for use
STERILISER