Preparing The Icemaker For Long Storage - Hoshizaki FM-481AGE-HC Manual De Instrucciones

electrical appliances in the bin.
* Clean the storage bin before use (see "III. 1.
CLEANING").
* Keep the scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the door after removing ice to
prevent entrance of dirt, dust or insects into
the storage bin.
2. The use of any electrical equipment involves
the observance of some fundamental rules.
In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
* Do not damage the power cord or pull it in
order to disconnect the icemaker from the
feed network.
* Do not touch the electrical parts or operate
the operation switch with damp hands.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
* Young children should be supervised
to ensure that they do not play with the
appliance.
* Do not attempt to modify the icemaker.
Only qualified personnel may disassemble
or repair the appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the compressor.
1. START UP
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position of
the operation switch on the operation panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the ice button.
Ice Button
ICE
DRAIN
STOP
MODE
ICE STOP RESET
Once STOP Button is pushed,
ICE Button cannot start ice
production for 20 min.
Operation Panel
2. SHUT DOWN
Push the stop button on the operation panel. The
Display will blink in the "STOP" mode for 15 minutes
during the drain control operation and will start to
illumintate constantly at the end of drain control.
3. PREPARING THE ICEMAKER FOR LONG
STORAGE
1) Follow the instructions in "2. SHUT DOWN".
2) Move the operation switch to the "OFF" position.
3) Close the water supply tap.
4) Remove the inlet hose from the water tap, and
drain the hose.
5) Disconnect the power supply.
6) Remove all ice from the storage bin, and clean the
bin.
III. MAINTENANCE
1. CLEANING
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, disconnect the
icemaker from the electrical supply network.
2. This appliance must not be cleaned by use
of a water jet.
3. To prevent possible damage, do not clean
the plastic parts with water above 40°C or in
a dishwasher.
3
ENGLISH
Display
Stop Button
Reset Button
Operation Switch
Fig. 1