Testing The M1700Ss Display; Installing Touch Software - 3M MicroTouch M1700SS Guia Del Usuario

3M™ MicroTouch™ Display M1700SS User Guide
Figure 12. Connecting the M1700SS Display Cables to your Computer
You should be sure all cable connections are secure -- tighten all cable screws.
Route all wiring and cabling away from heat sources and sharp metal edges to avoid
damage. Also, keep the touch sensor cable away from sources of electromagnetic and
radio frequency interference.

Testing the M1700SS Display

Note: The M1700SS Display has a power status LED located on the front of the bezel.
After connection, turn on the power switch located on the front bezel.
Turn on your computer.
1.
Make sure the video image is displayed. If it is not, turn on your display. Ensure the
2.
LED is green – orange indicates power but no signal.
Make sure the video image is centered within the sensor area. Refer to Chapter 3 for
3.
more information on using the on-screen menu to adjust the video display.

Installing Touch Software

A 3M™ MicroTouch™ touch driver is required to operate your M1700SS Display.
Refer to the MT 7 Software User Guide for complete instructions. These drivers and
relevant technical documentation can be found on the enclosed 3M Touch Solutions CD
(31197) and are also available for download from our website at www.3m.com/touch.
After the software is installed, restart your computer to load and activate the touch
driver.
Document #19-268 Rev AN
15