Replace Protective Nozzle Seal; Replace Print Cartridge - Reiner jetStamp graphic 970 Manual De Instrucciones

jetStamp graphic 970

5.4. Replace Protective Nozzle Seal

Replace Protective Nozzle Seal
Depending on ink type used, different Protective Nozzle Seals are required.
Push down the Protective Nozzle Seal
f
Take it out at the Protective Nozzle Seal tip
f
Insert a new Protective Nozzle Seal into the holder.
f
Slightly push down the Protective Nozzle Seal until it latches in the holder.
f

5.5. Replace Print Cartridge

The ink level of the print cartridge can be determined in the status display of
the PCSet graphic software
Replace print cartridge
Depending on ink type used, different Protective Nozzle Seals are required (see "Re-
place Protective Nozzle Seal").
Put the jetStamp graphic 970 in the base station
f
Turn the setting wheel
f
Keep the trigger button
f
3
Print carriage moves to the middle position.
Slightly push the lock of print cartridge
f
can be opened.
Open print cartridge flap
f
Remove print cartridge
f
Take new print cartridge
f
15
nozzles .
Put the jetStamp graphic 970 on a fixed flat surface.
f
Inserting printing cartridge
f
Closing the print cartridge flap
f
Push the trigger button
f
3
Print carriage moves to the home position.
Fig. A + D

5 slightly at the front edge.
16
.
d
.
Fig. A + B + D

7
to position 1.
1
pushed and take the device from the base station
13
to the right, until the print cartridge flap
11
.
12
from the device.
12 from the packaging and remove protective film from the
12
.
11
.
1
.
4
.
4
.
11
GB
67